Cart is Empty
The A-TAC ferrule is machined out of a solid brick of stainless steel and features a 5/8� cutting diameter on the 100 gr models and a 3/4� cutting diameter on the 125 gr models. A single piece, stainless steel blade slips through the ferrule and locks into place to round out the four blade design. This 0.080� thick main blade is twice as thick as most blades on the market and honed to a razor sharp edge. The cutting diameter of the main blade is 1 -1/8�.
|
Incorporating CNC stainless steel construction, an Air-Channeled tip, blade-over-shaft design and an integrated containment ring, Quad Steel will fly true and give you the results you’ve been looking for. Cutting diameter 1 ¼”.
|
The patented T-Shaped connection between the blades prevents separation of the Shuttle T-Lok blades from the ferrule even when fired into solid bone, concrete and metal. The sweeping blade angle also increases the total amount of razor blade surface without increasing overall size. The resulting oversized holes devastate game. The non-vented blades increase penetration and make flight silent. Cutting diameter 1 1/8� on 100 grain, 1 3/16� on 125 grain.
|
The patented T-Shaped connection between the blades prevents separation of the Shuttle T-Lok blades from the ferrule even when fired into solid bone, concrete and metal. The sweeping blade angle also increases the total amount of razor blade surface without increasing overall size. The resulting oversized holes devastate game. The non-vented blades increase penetration and make flight silent. Cutting diameter 1 1/8� on 100 grain, 1 3/16� on 125 grain.
|